Author of work-Kokorina Hope.
Today I will show how I do a car thread. This is my first master class, I hope for understanding and your support. Many people are interested in the process and I briefly state it in my publication.
Materials:
1. Blank of wood,
2. Cutters,
3. Pencil
4. Stack,
5. Morida non-aqueous "Oak"
6. Tree for wood,
7. Airbrush,
8. Compressor
My helpers are cutters.
Unknown Morid "Oak", airbrush, sandwich 2 species (zero and coarse)
To cut a plate, we need a billet from a tree. Now many craftsmen are offered to sell the workpiece. I made a familiar master from the cedar. Then we think about the sketch, I have Ural Nature and the Holder.
1. We make a drawing with a pencil.
2. And then take the cutters and begin to cut. I usually begin the plates from edging, here I have cedar branches and cones. I try to cut immediately purely, so the stacker will practically do not need. Only at the end to give a pure type of product, remove the remaining pencil from the tree. As well as the stacker will need when painting work, but later. Observe caution when carving, we break your fingers. More When you cut different products, mark that the plate is cut more comfortable in terms of cleaning.
Mostly the whole chips will be inside
3. I refer to the pattern, which I printed for clarity. First, I work on the branches, and then turn to the cones. Although here a sequence is not so important, you can do at your request.
4. Then I turn to the thread of the muchahar cut out the outline and remove the background.
5. Doing the owl of the bird. Here, the result is such a plate.
6. Slightly passes the sandpaper and getting ready for painting. Although the tree has recently like not toned, clean. So more natural beauty in it. But the tree must be protected from many factors, dust, moisture. So I make a coverage. I want to try to cover the wax in the near future.
At the moment, Tinuing the non-aqueous overwhelming oak and cover the wood lacquer. Maybe a glossy varnish and matte to your taste. Then brush with a brush with wood dust, I am preparing to paint. Tinging an airbrush. Since I haven't purchased it yet, toned from a friend, I do not have these photos. But the process of tinting is as follows:
1. Finding a common tone from the airbrush.
Photo of airbrush.
Photo of the compressor to which we attach an airbrush and painting.
2. The slave plate, the paint remains only in the thread.
3. Then cover the product with varnish on the one hand, it should dry. The time depends on the varnish you chosen, it can dry in a day, and nitra dry out in 1.2 hours.
4. Then cover the reverse side of the plate. Waiting for dry.
5. Finally influenced product grinding. So, after the lacquer, the tree is a bit, it becomes places to be rough, it will be necessary to grind and lacquer. If there are leaks remove the sandpaper.
6. Covered on the second time lacquer for the same technology. The plate will dry and if there are no flaws of varnodes, it is ready. If there is roughness for another third time we vych. This is not a quick process of manufacturing a plate, but the result requires that. Let you please your carving and brings joy to other people. After all, the tree is such a beautiful material and he carries the power of good people!
In the photo two types of painting, lightweight tinting, light wood effect to keep more natural wood.
And darker toning. With the use of moroli oak and ebony tree.
Wish you luck! The tree will bring a lot of positive emotions!
Maybe someone from you want to touch the tree and cut your first job.
Special thanks to Olga, who made the order of the plates, I was able to extract the manufacturing process and recall how cool to work with a tree, what kind of malleable material and how it smells like a forest.
A source