"Venetian lace" - decorate a cutting board

Anonim

Decor

This decorated "Venetian lace" cutting board will be a great gift for a housewarming. And in general can decorate any kitchen. And here is the master class:

1. I whipped the cutting board, which would be a smooth, nice to the touch.

1 (635x476, 145Kb)

2. Come on the edges of painting scotch. It will be the working part. We do not plan to eat paint and lacquer, so it is not desirable to enter the listed on the work side! Yes, and aesthetically try to do everything neatly.

2 (635x476, 138Kb)

3. Mock the board and the ground the decorated side. I am a little wetting the brush in the water. The primer to go to bed.

3 (635x476, 126kb)

4. We pull out the selected pattern, we relax, stick. I am glue immediately acrylic varnish. Napkin will not charge so much and less the ability to break it

4 (635x476, 162Kb)

5. Covered sponge surface without pattern white acrylic paint. Envy. Skin. The surface should be smooth. Without traces from the sponge.

5 (635x476, 173Kb)

6. We take an openwork napkin. From the reverse side, we spray temporary glue and apply an angle.

6 (635x476, 206Kb)

7. We recruit brown paint on a sponge and pass through the outlet of the napkin. I do not give much. Polyels can turn out and the ease of the lace pattern will be lost. We dry and gently remove the napkin.

7 (635x476, 237Kb)

8. The remnants of the adhesive can be pulled by shallow skin. And again the board is smooth :-)

8 (635x476, 191kb)

9. On the sides of the boards we pass with a sponge with brown paint.

9 (635x476, 188Kb)

10. We start working as cracker. We need 2 stepplings. We decide in advance where we will make cracks. We apply the first layer of varnish number 1, and we are waiting until it gets up, but will remain a little sticky. We apply the second layer of varnish number 2 and the dry hairdryer before the appearance of cracks. Gain must be good!

10 (635x476, 151kb)

11. Coating acrylic varnish and after drying, we drag the cracks of the patina.

Surplus of patina can be removed with a cotton disk moored in vegetable oil.

Next, 5-6 layers are coated with acrylic varnish.

11 (635x476, 142Kb)

12 (635x476, 149kb)

12. Well, the final moment of truth)). Remove the malarious scotch and lachm the last time. Latchy so that it would go a little on the working surface. We will not let me get water under the paint. Well, if you drove a tree very much, Oshkarim is superfluous.

13 (635x476, 106Kb)

13. Tie a ribbon. Iii ........ !!!!! Masterpiece is ready !!!

A source

Read more