What you need for needlework
In order to independently make beautiful earrings from felt, you need such tools and materials:
- pieces of peach and red felt;
- decorative chain;
- beige threads, needle;
- transparent glue;
- scissors;
- chalk pencil;
- Rhinestones are plastic for needlework;
- small pearl bead beads;
- nippers;
- round-rolls;
- Schwenza (the basis for the serg, which is inserted into the ear);
- Jewelry cloves.
Step-by-step equipment manufacturing
Cut on the template 4 of the same leaf from peach color felt. From the red material cut 2 squares with a side of 2-2.5 cm.
The leaf at the base is twisted so that a cone-shaped figure formed.
A needle with a thread, gripe the fastened sections with secret stitches. Seam do not tighten. There should be a twisted leaf with an internal cavity.
The nodules hide inside so that it is not visible from the front side.
List straightens, give it a beautiful shape.
Sust in this way all the details.
Remove red plastic rhinestones. On the opposite side, apply a little glue and put inside the leaf. Place the rhinestone so that it can be seen from the rounded area. Stick the decor on all the leaflets to decorate earrings and set them out to the glue back.
On the center of the Red Square, apply a little glue.
Square Take two fingers and roll in half.
Then adjust the two opposite side of the workpiece. Hold your fingers the base of the shapes and keep so far before drying the glue. At the same time, create a similarity of inflorescences with petals - the main decoration of felt seagle.
At the finished flower, straighten the petals so that they are located at the same distance from each other.
Put the flowers aside, they must dry.
From the decorative chain, cut down a two pieces with a length of 3-4 cm.
One end of the chain section to the base of the leaf.
The second sheet of felt Success to the second link, which is slightly higher than the first.
Send so that they are located in the same plane, one slightly above another. At the end of the thread output the sheet and secure there on the nodule.
To the other side of the chain of earrings. Sweat red flower from felt. The nodules disguise inside the part so that the earrings are neat.
Flower sew so that the inflorescence is from the same side as the facial sides of the petals.
The edge of the carnation for jewelry jolts the flower from the opposite side of the chain. In this case, the hat will be inside.
From the outside, put on the bead.
Move it close to the flower. Then put on the nail Schwenza for the seagh.
Press the Swenza to the bead, cutting out a piece of carnation so that 6-7 mm remains.
Circlemakes Wrap the remaining part in a small loop.
Raise the earring for Schwenza. The top details of the product must fit tightly to each other.
Praise yourself for diligence - you made wonderful earrings with your hands from felt!