Take a look at this charming colored hat with a texture pattern. To create it, the master needed only threads and some free time. The knitting and hook here were unnecessary: the whole hat from beginning to end is connected on the hands.
At the same time, the technique is not at all difficult, it is possible to master it even in the absence of knitting skills.
Yarn for such knitting should not be fine, otherwise knitting will be loose. It is not necessary to take an overly thick thread, otherwise the fingers will have to keep all the time in the raops.
Laying row begins between large and index fingers. Holding the tip of the thread with a thumb, deposit the wave. We twist index from the outside of the brush, the middle side - from the palm side, nameless again with the outer, and the little finger with the inner with the occasion of the full turn.
We pave the wave in the opposite direction. As a result, each of the 4 fingers will be wound completely. The working thread required to create the next row is again from the outside. A series consisting of 2 waves made in opposite directions is completely laid. Immediately lay another row. In the course of all knitting on the fingers, 2 groups of loops should be at the same time. Work on their movement always begins with a mother's maiden.
Capturing the bottom loop, remove it so that the top remains in place. We do it from each loop of the lower row, moving from the little finger to the index finger.
The first row is accuited. We pave the following row. As a result, the upper loops appear below. Remove the lower loops again. In fact, it is all.
As a result of such knitting, a volumetric strip is obtained with a characteristic texture pattern. The top edge to go to bed with a neat chain.
Convenient is that at any time you can interrupt work. Upon completion of the row on hand, there are only 4 loops, which are extremely simply moving on a pencil or needle.
The first task is to drive out the strip corresponding to the scuffing of the head. You do not need to connect it into the circle separately. It is done directly in the course of the work.
Hooking immediately for 2 halves the first one-piece chain of the contused band, we put it on the little finger, and only after that we put another row. As a result, on the inside of the maffer instead of one thread, it will be 4, and on the other fingers, as before, 2.
Closeing a row with the little finger at once we remove 3 loops at once, or rather the bottom loop and chain. The remaining loops remove the usual order.
Before laying another row, we find the next one-piece chain and we ride it on the little finger. So moving in a circle throughout the knitting. In essence, we just do the spiral speaking.
By making the decision to change the color of the new thread introduce from the index finger. I drive a smooth tube until the header needs to be relevant.
The essence of the recess is to reduce loops in a row. This is achieved by passing one chain. Now you need to wear the first one-piece chain on the little finger, but the second. As a result, the spiral will gradually go to "no".
By the end of the knitting, we reduce the number of loops on the fingers, taking them in pairs, and then stretch the thread through the loop assembled on one finger and delay. Fix and break the thread. All tails are displayed inside out and refuel. Then it remains only to supplement the cap pompon.
More details about knitting the original hat on the hands in the video below: