Well, today I will share another type of roses from the tape. This time I will make rosette from a ribbon 1 cm wide.
What is extremely important for me - so that the creation of the flower is as simple as possible (few people like difficult painstaking work), and the result pleased the eye.
This requirement, I think, is well suited to this rose. It is done simply and on her creation takes a small amount of time.
So, we will need:
1. Ribbon width 1 cm.
2. Glue, any suitable for fabric. I used a glue gun.
And that's all we need to create a rose.
Next, to create a composition you use the materials you need: other color tapes, accessories, fastening. But I leave at your discretion.
We take a ribbon and "tie with the edge of the knot", but do not tighten, but just gently spread it. The first "nodule" is better to fix glue.
Next, "tying" the second nodule. It is not necessary to fix it.
The third "nodule" and so on ... the last nodule is also fixed by glue.
In total, these nodules can be from 11 to 15 pieces.
Next, begin to twist the rush using only glue.
Lubricate the bottom (flat) part of the nodder glue.
Spin it with a tube, getting a core for a flower.
The following nodules are similarly lubricated with glue below.
Wrap around the core.
Third nodes.
Petals are obtained volumetric.
Thus we collect completely rose.
It's all. So, quickly and easily, the pretty roses are obtained.
Next, where to attach these flowers - the case of your imagination. Good luck.