We will need (Fig. 1):
- 10 cocktail tubes (1)
- Satin or repus tape length 1.5m (2)
- Thread and needle (3)
- Gold paint-spray (4)
- Scissors (5)
- Wire for jewelry length 10cm
Tubes cut 3 - 3.5 cm long (Fig. 2). Very accurate to extinate no need, because A small difference in length for this decoration is welcome. You must have 60 cutting tubes.
We ride the segments of the tubes on the thread (Fig. 3).
Praying their gold spray paint (Fig. 4).
It is better to paint in two layers. Apply one thin layer, give dry and then apply the second layer. Try to spray paint so that it gets inside the tubes (so that no one doubted that they really are golden). We wait until they finally dried.
We make two loops from the jewelry for jewelry, which are tied to the thread, on which the tubes are risen (Fig. 5).
The ends of the satin or repetitive ribbon we fall, we draw in the loop of the wire (Fig. 6).
Tie the ends ribbons with a bow (Fig. 7)
And our exclusive gold necklace is ready!
We hope our master class will help you in the manufacture of this unusual gold necklace!