I decided to build a clock on the wall in the room. I wanted two mechanisms. I will try quickly.
In the Chinese store, two smooth silent mechanisms for 150 rubles were ordered. Two saucepans of 100 rubles were purchased in economic.
With the help of jigsaw and hacksaws, the saucepans are mercilessly poured, and the lids solemnly awarded his wife.
While his wife was happy with the new lids and wondered where to adapt them, she had a plate on her time. Used as a template for cutting a glass. Plasticine for fixation.
Kerosene used the resh was easier. Glass-2.5 mm.
From the list of DVP cut out two circles-future dials. Ring from a piece of pipes Metal-plastic 16. The ring is needed to be between the glass and the dial there is a place for arrows.
Glass pasted on thermoclauses. In the sewing store bought a ribbon for rings-15 meters 3 rubles. The dial saves wallpaper remnants, the numbers cut out from the film for the car.
Pre-assembly and fitting. Half.
From a piece of child, I cut the docking ring for halves of hours. The lower part is Ballast, so that the center of gravity is at the bottom and the clock hung exactly at one point of the support. This ring is inserted half into one of the parts.
Halves are going to simply. I did not use the loop. It is kept on the docking ring very tight. The alight of the mechanisms provide two vertical screws that fasten the suspension. We are shattered, too, simply slides the slot with a knife. Painted acrylic matte white paint.
From 10 mm plywood cut fastened on the wall. Painted the same paint. The exchange rate is fixed by self-drawing, they will not fall off. Clock heavy.
In the fastener shop, handles were bought on furniture-80 rubles. Bent on the case of the clock. Suspension ring spoiled from his wife with a bag. Clock assembly.
It remains to hang in place. Studs M8. Wall brick.
The calf hangs smoothly! The phone takes off this angle so. . On the other hand
Fresh.
Well, the last side view. Everything!
