Oh, what a chic jacket in two versions: for theater and street (modest)! Knits knitting.
![]() | ![]() |
Jacket made with spokes of yarn - mink imitation
Size 42-46
You will need: 950 g VISON yarn (LANAS STOP) - imitation of mink; Smoky dark gray colors (No. 102, 95% viscose, 5% polyamide, 63 m x 50 g),
Spokes with a fishing line No. 4.5 and No. 4 for the sleeves cuff;
needle for knitwear; Large and small fasteners with rhinestones.
The jacket is made of "fur" yarn knitting number 4.5 facial stroy. The model is connected without seams, from the bottom up, from the lower edge of the Baska with one web to the arm. The sleeves are enshrined in the armor. The collar is tied with the main web. The jacket is fastened with a decorative large clasp with rhinestones, in the corners of the collar are sewn parts of a small decorative fastener, adorning the postponed collar, as well as allowing it to fasten it as a large soft rack. By sample, associated facechair Make a loop calculation.
Tip: Since the knitted canvas is imitation of fur, I advise you to knit all three parts from individual clubs at the same time before the shoulders start to avoid errors.
Important! The shelves and the back of the jacket are knit from the tip of the thread coming from the edge of the tangle, the sleeves - from the tip of the thread; Going from the center of the tangle, since the pile of yarn falls in a certain direction.
Type the double number of loops, tie 4 rows with a handful viscous hinges, continue to work as a facial stitch. After 12 cm, check 2 loops together face. Next, knit the shelves and the back of the jacket with a single web to the face of the facial stroy. Divide the cloth into three parts, each of which knit from a separate tangler, adding a hinge shelf at the edges to form a scanned collar.
Shoulder SCOS Remove shortened rows. Sushe out open loops shoulder knitted seam.
Tie a collar (10 cm front stroke, 4 rows of sweating viscous), continuing to add hinges at the edges to form a bevel. Close the hinge needle.
To knit the right sleeves, jacket tying the hinges from the edge loops. Mark the marker conditional seam line. Tie a sleeve in a face with a face, having reduced the loop at the conditional seam, before the cuff. Go to the knitting needles number 4 and tie the cuffs with a handful viscous. Close the hinge needle.
The left sleeve of the jacket knits in the same way.
Assembly. Type the loop on the side edge of the shelf and the collar, tie 4 rows of sweating knitting. Close the hinge needle. Slightly process the jacket with an inside with a sppachener, gently decompose on the horizontal surface (on the pattern) until complete drying. Sushi fasteners with rhinestones - large on the breast line, small in the corners of the collar, as shown in the photo.
Pattern for knitting needles