Look, truth is pretty. In the technique of origami. I tried to fold the box of the newspaper for the day, I liked it. Especially fascinating if it turns out right away!
So fold bows!
It is necessary to have a square of a thin paper, in the sense, not watman, of course. The size of a square depends on the size of the square. But with a small square harder to train.
If you use paper on one side with a pattern or painted, this side you need to put a sheet down.
one.
2.
We put the leaf horizontally, bend in half and stiff well, they are important for us.
3.
Deploy sheet and fold in half another line
four.
It turns out like this. Deploy the leaf, swing well fold
five.
Now bend the sheet to diagonals
6.
And in the other side - the same. We should get like this: 2 bends horizontal, and 2 verical
7.
Follow the lines and try to fold the sheet so (the red side was lying down at the bottom):
eight.
Press the figure, as if closing it. And start the upper triangle, as in the picture below, lay well fold.
nine.
Now reappear the sheet again as in the photo below. You see a small square in the center, resembling a large square in shape and bend. Now we need all the bends to go again to fix them on a small square.
10.
like this:
eleven.
Fold the sheet just like on the 7th picture above, with the exception of the central square
12.
Now we have a middle square to remove inside, as in the photo below. Immediately may not work, but if we took a thin, then it can be removed down the lines (they are clear) ...
13.
It is difficult, but you can. Now the leaf we have two-layer: a large square and inside - the one that is less. The whole figure looks like a photo below:
fourteen.
Behind the upper corners down, as here:
fifteen.
Turn the sheet and repeat - remove the other side
sixteen.
We have to open a figure, leaving a small square untouched
17.
Our facility should look like the photo below, after we open a big square
And leave closed small.
eighteen.
I turn over the sheet, we make sure that we did the same as in the photo. So?
We cut along the fold line (where black lines).
nineteen.
After the cut, we get parts that can move: 2 down and 2 up. These two parts will be a tail.
twenty.
Fold the top down and run the edge
21.
Side parts bend down, as shown:
22.
Also fold another edge.
23.
Now we lower the tail, we fold the edges, cutting both parts in the center where the black line (make sure you do not cut on the center)
24.
Now maintain it as shown below
25
Transfer
26.
Bend the corners of the side triangles to the center
27.
Cut the tails of the bow and that's it. Ready! It was not too difficult?
Just some kind of mathematics ... But those who do not like ordinary solutions, I think you will like it.