In winter, did repairs at the cottage. Several sheets of chipboard remained unused. Since I have long dreamed of furnish the veranda of furniture, I decided to make a small sofa from an unlikely sheets.
That's what happened.
This sofa is made quite simple. In the photo, the design is clearly visible. Cut with a saw or electric bison three identical lateral parts. The sequence is screwed to them the screwdriver.
Exactly the same detail of the chipboard serves as a back. Cut another part of the same length, but the width is determined by the experimental way. So that the legs were convenient if you want to push them a little under the sofa, but also to close the side of the sidelines.
I screw this bar on the front below the sidewalls.
Here, in principle, the whole design. It is so simple that everyone can repeat it.
To sit was not rigid, I got two large rectangular pillows from the foam rubber in the size of the seating and backs. At home, the wife truncated a fabor with a cloth from the old winter curtains.
Now it remains only to bring the gloss to our sofa. Chipboard I first rejuvenated well. All end surfaces and joints sushpakleval. When the sofa is dry, fine sandpaper polished the surface.
It remains only a roller to paint the prepared sofa.
On the perimeter of the seat with a construction stapler grabbed the velcro tape (Velcro). The second part of the velcro fastener sewed a wife to the pillow. Just acted with the back. Now sit gently and you can remove and wash the pillows.