1. Preact scissors using the stationery clips
We take the usual metal stationery clip.
The more its size will be the better.
Sharpening technology is as follows. Scissors clamp the tip of the clips.
And, slightly squeezing the knives of scissors spending a clip to the intersection of knives.
Next, we remove the clip. Repeat these actions 30-40 times. The relevant notches appear on the clips.
2. Use the battery case
For shafts, you can use a finger battery, but necessarily in a metal casing.
All the actions on the shaft are done in the same way as in the example with a clip. Movements must be made from the tip of scissors and before the intersection.
3. Using sandpaper
In this example, we will use sandpaper. The smaller its grain is, the better. It is better to take "zero". Everything is very simple here. Cut it on thin strips. At this time, the blades nod occur. Do not forget to turn the paper on the other side, so that the knives are evenly rolled, or simply fold it twice.
After that, to smooth the surface, cut a napkin.
4. Glass sharpening scissors
Any glass is considered a very solid material. We take a glass bottle and about her neck the exact blade. On the bottle should remain notches.
Be careful because the glass crumbles.
5. Using Foil.
We fold the usual food foil in 4-8 layers. Just as in the example with sandpaper, cut foil on thin strips.
40-50 cuts should be enough.
6. Using a screwdriver
We take any screwdriver and rest in a solid surface. Press the screwdriver rod with a slight force with a slight force of scissors. Repeat operation 30-40 times.
7. Prefer
Cleash the scissors in vice in the open to a maximum.
Nadfil are passing along the cutting edge from the middle to the tip.
At the same time each side separately. Instead of the proper, you can use a grinding stone.
8. Draw a metal sponge
Also scissors can be molded simple cutting the metal sponge.
After sharpening scissors, be sure to remove wear products: metal chips. It will not be superfluous to lubricate the blades.