How I make a mass for the modeling of street figures

Today, I want to share my recipe with you)

Take a tray from under the eggs and begin to tear into small pieces

Good evening, dear residents of the country of Masters! Today, I want to share my recipe with you)

Take a tray from under the eggs and begin to tear into small pieces

That's about such ...

You can pour hot boiling water and wait for about 12 hours, but I prefer to boil, for fast use. We are cold hot water so that the peasters boiled

We put on gas. Plate and wait when boils. Then "Cook" 20 minutes ...

Here is such an adaptation for whipping. Drill + Venchik from Mixer ...

20 minutes passed and we begin to "beat" ... We start with the bottom lifting all the pieces on the upwards, and then clockwise or how it turns out) so "whipping" to the pushing mass.

And again put on gas. Plate for 10 minutes ... Remove and beat again ... When the mass becomes homogeneous, then we leave cool.

We will add this putty to the ground.

We take cold water and wept the putty on the description on the package ... I use a 5-liter. I dial, I pour about 1/4 of the cold water and dilute the shta ... You can also add the glue PVA. I will debug "just in case" Little is not enough ... the shp can be like a thick sour cream, but not too.

Press the egg-cardboard mass of water. I use such a grid.

We add a cleaned mass into the shta and mix. Let's prevent carefully ... and get a magic mass for the modeling of our works ... It is advisable to use it right away, because through time it begins to push ...

Here is such a charm ... if it is too dry, then add a little water ...

That's how !!!

And as a result, these are

And such winchs