How at home, make a lightweight convenient machine for embroidery from PVC tubes for wiring
My homemade embroidery machine is very easy and quickly done. Time took - 40 minutes.
The cost of 260 rubles came out.
Such a machine can make any woman herself.
Good access to the offline (Rotation of the frame for 360 g), but most importantly - it is very convenient for fastening the knaps or for self-made PVC pipes! PVC pipes for wiring buy in electrical stores.
Water pipes are not suitable (they need to attach connections on special devices), and electric pipes are very tightly included in the compounds.
We have to:
Hoven for metal
2 bolts (№40) long 50 mm with lamb
Pipe plastic (diameter 20mm)
Fittings (connecting elements in the form of corners and tees)
Clamps for pipes (half-leavers for fastening pipes to the wall) + 2 Rubber Round Gaskets
and desire.
All sizes depend on the size of the KNAP frame, so first:
1. We collect a frame of the type of ku-dreams - saw 4 segment pipe and connect 4 corners
2. We connect the locks for pipes (we put on the bolt, and between them put the rubber gasket to facilitate the rotation).
3. Insert a kift to the clamps (the fixator for fastening the pipes of the diameter of 25mm and the lock for pipes is 20mm). Therapy is made from pipes with a diameter of 20mm, but due to the clips and thickness of the canvas, we take 25mm.
4. We begin to cut off pipes for the machine (be sure to take into account 1.5 cm distance (thickness of two folded fixators), segments connect fittings (corners and tees). Rapid (hot) nails Make 2 through holes for inserting screws with locks for ku- Snap, insert, fix the lamb.
We connect the fantasy, design, select dimensions.
The machine can be made desktop, sofa and even outdoor.
Attach additional tubes-planks for fastening the scheme, organizer, firmware.
After collecting your plastic machine, I do not use expensive wooden, plastic is much more convenient.
Sizes of my machine:
Measured along the outer side assembled with the size of the fittings (corners)
1. Frame I have American 43x35 cm
2. Nizhny rectangle (fixed on the table stand 30x54 cm (this is the bottom base of the machine stand). For the outdoor option, I would have made 45x54 cm (for stability)
3. Long planks (their 2 pcs) on which fixators for frame ka snap 45 cm
4. Length of the tube on which the organizer for threads is attached in the photo is 54 cm - this is the width of the machine (it logically is equal to the length of the strip of the bottom stand-rectangle 54x30 cm)
5. The length of the tubes on which the pipe holder is attached (they connect the tube from paragraph 2. and 4. - 15 cm
6. The height of the desktop (as in the photo) is 22 cm (these are sidewalks) - (for outdoor 75 cm)
7. The height of the pipes for the diagram and the lamp (there are 2 - on the left and right) 20 cm (and in general arbitrarily)
a source