New connectors appeared on sale, which not only isolate, but also soldered the wire inside the insulation itself.
Very similar to a simple heat shrinking tube, but unlike her not only isolates, but also soldes the veins internal solder!It looks like fiction, but let's buy in more detail where to buy and how to use.
Need
- Hairdryer, pocket gas lighter will also fit.
- Special heat shrinking tubes for splicing wires.
One tube consists of several components:
- - Heat-shrink insulation itself,
- - two crimp rings on the sides - contributing to the complete sealing of the entire compound,
- - and the central ring with flux and solder.
Connect the stranded wires
Now practice. First of all, we select the tube of the heat shrink connector under the diameter of the wire connected (which is why it is better to buy a set of such tubes).
Remove isolation from both wires, approximately 1 centimeter on each side. Next, one of the ends wear the connector.
We join the fluffy lived inserting them into each other so that they intertwine as much as possible with each other.
Then this twist can be slightly squeezed with hand and put the connector tube so that the solder ring is exactly in the middle.
We turn on the hairdryer and gently blow up the heat shrink.
In order for the tube exactly lay down on all wires, it is advisable to start with the middle.
And as soon as the wires are shed - we begin to blow the side moisture absorbing rings.
After that a pair to go to make cool down.
Outcome:
As a result, a moisture-resistant, high-strength connection of two wires is obtained. By time it turns out much faster than with a classic cleaner.
No need to brighten or clean the wires. Active flux and solder inside will make their job.
Since instead of a hair dryer, you can use a pocket gas lighter, then such connectors are just a find for car enthusiasts.
A source