Young trees of some breeds can be raised right at home. In the spring, if the plants are quite hardened, they can be taken to the garden. The author of this project raised several young bone trees and was looking for a solution for an inexpensive and convenient plantator. Among other things, lawns were to decorate the garden. To implement the project, it took a pair of old plastic barrels and trimming sawn timber.
Even halves of barrels are enough for small plants.
The plastic perfectly performs the function of the vase, but it is not striking because of the trim from a natural tree.
The atmosphere of the natural garden is not broken.
For this project barrel managed to buy on sale. Even those on which there are small cracks are suitable.
To make a high lawn, you need to cut off the upper part. For a start, make a cut-off line with a marker that the edge is smooth.
For low lawns, one barrel is cut in half, and the upper part will become the bottom.
Two planter will come out of it.
Using drills, drill a plurality of holes in the bottom of each part to ensure good drainage.
Place the holes over the entire bottom surface.
With the help of two small bars screwed to the bottom, the lawn is slightly lifted over the ground. So drainage will work even better, on whom the barrel is not located.
Bruks are fastened with screws and fixed with washers.
Next - the revision of the existing stocks of wood.
There will be even small pieces.
We need long boards for sides and short - for formwork lawn.
All too much cut off, and the surface was cleaned.
You can start assembling.
For the start of the board are nailed along the area of the cylinder.
The edges should not touch the Earth, so put a small bar for them.
Nails are perfectly coping with the task. Therefore, the plastic barrel is the best choice for this project.
You can let the brackets of the mustache to create a more interesting texture.
So everything will look from the inside.
The formwork is assembled on the working surface, and its edges are fixed with an insulating tape.
If necessary, you can enhance the edges.
Secure the formwork to the board boards with small nails.
Large holes in the bottom were covered with a small grid to prevent drainage and soil dropping away.
The first layer is a small crushed stone.
Next, soil. Pick the one that is better suitable for your plant type.
Final barcode - tree landing.
From above, you can add large wood sawdust - they will protect the soil from drying out.
This beauty turned out of the most affordable materials.