Viewing the old trash in the garage or on the balcony, you can detect a lot of interesting things. For example, old furniture, in most cases, she has already lost its presentable look, but it can be restored and give it a new life. We will conduct an experiment with the old kitchen table of Soviet times.
Restoration tools:
- Marker permanent;
- Long line;
- Wood hacksaw;
- Glue ("moment" or any other superchalter);
- Cold welding;
- Pliers;
- Drill.
We will also need a small size sheet chipboard and self-adhesive film with color pattern.
Process transformation
The beginning of our reincarnation will begin with the parsing of the entire design. We unscrew the tabletop and disassemble the wooden base itself, unscrewing all bolts and removing the iron brackets.
By idea, the table is planned to be twice as fewer. That is, the former width of the table will be its current size. But the dimensions can be chosen at their discretion, it all depends on your imagination.
Next, at the ends of the unpacked boards that serve as retail crossbars are made for metal brackets (focus on the former mount). On several edges of the crossbar, old rods and holes for holding bolts will remain. On the places of new rubber, we make a drill hole for future bolts. Since the old holes fumbled, they need to pour the "moment" glue and insert a match there.
If the old stands of the tables dangle or fall out of the grooves, then their threaded connection, it is also necessary to deceive with glue or cold welding and screw it back. According to our plan, the legs inhibit approximately half.
After some time, necessary to dry and set the combined structures, you can start assembling the design. By collecting the basis of our future table, you can proceed to drinking tabletop. From the prepared sheet of chipboard, cut the required size, the table lid. We process edges with a brine with a large grain or sandpaper.
Next, we carry out the layout of the holes for fastening to the legs. It is very simple, put the base on the inside side of the table top and mark the layout of the legs. Drills holes so that they are located in the center of Brousa. Larger diameter drill make small recesses for immersion screw screws flush. Mount the table cover with screws.
Now we can only enclose the resulting design of a self-adhesive film. And we turned out, quite a handsome coffee table.
