Openwork takes beautiful patterns on the needles Openwork beret Stops from the top to the gum. The main part was performed by the drawing of Zigzag, and the top of the beret was crowned with openwork leaves.
Description of Beret is translated from the book Heather Zoppetti "Everyday Lace".
The size:
Elastic circle - 53.5 cm.
Used yarn:
SPUD & CHLOE FINE (80% Merino wool, 20% silk; 227 m / 65 grams in the MOTK) - 1 Skok.
Required tools:
Circular spokes No. 3.25 with a length of 40 cm, a set of double-edged spokes No. 3.25, markers loops, a tapestry needle, auxiliary thread, a plate with a diameter of 25-28 cm.
Knitting density:
28 loops and 40 circular rows of openwork mating are 10 cm.
Start knitting:
Double-edged spokes to dial 5 loops using a circular hinge set shown in the video lesson:
Distribute loops for three knitting needles, mark the beginning of the row and connect the loops into the ring.
Tie the ranks 1-37 according to the scheme for the top of the beret, tagging in each row 5 times the rapeport of the picture.
Top Scheme
When the number of loops will increase on the spokes, and it will become inconvenient to knit, go into circular needles.
After the 37th row on the spokes there will be 170 loops - 34 loops in each rapport.
Next circular row: Tie the 38th row by performing a rapport 5 times, and zooming the loops from 34 to 38s in each rapport - all the spokes of 190 loops.
Tie rows 39-66 schemes. After the 66th row on the spokes, 120 loops will remain - 24 loops in each rapport.
Tie 1 series facial loops.
Next circular row: * 1 Facial loop, 1 Initious loop; Repeat from * to the end of the row.
Tie 2.5 cm with a rubber band, repeating the last row.
Close all the gum loops with an elastic method shown in video lesson:
Ending:
A tapestry needle with auxiliary thread lay the corresponding line along the border between the main part of the beret and elastic. Moisturize takes and pull it on a round plate or plate. Tighten the thread, preventing the stretching of the gum on the form, while the openwork pattern should be stretched.
After drying Openwork beret Remove from the form and remove the auxiliary thread.
The gum fit on the spokes number 2 mm, the openwork pattern on the spokes No. 2.5 mm.
On the girth of the head 54-56 cm. On the knitting needles No. 2 mm to dial 128 p, closure in a circle and knit 2 faces with a rubber band. 2 is elevated. 4 cm (I have 18 rows).
After the rubber band, we turn to the knitting needles No. 2.5 mm and knit 1 auxiliary series of persons. Loops, which evenly add 28 loops (there will be 156 loops on the spokes).
Schemes are given only the odd rows, in the even rows of loops knit in the drawing, nakid - facial (knitting circular).
Next, we distribute the loop for the pattern. It will turn out 6 braids and 6 diamonds.
In the last row, the remaining 6 persons. and 6 is elevated. Loops to stick two together face and pull them on the thread.
After washing, it takes to impart a round shape to pull on the suitable plate or lid and dry in this position.
