The location of the wretched relative to the waistline in the original construction of "Puddles" It is assumed that the middle of the mitigation line should be perpendicular to the waistline.
It was repeatedly emphasized in the description of the construction that the "patch" is not a model, not a style, but the "thing" ideally describing your figure.
The perpendicularity of the Middle line of the waist line of the waist lines allows not to equalize the cutting side when constructing, which greatly simplifies the construction of the base for beginners.
Beginners of sewing lovers, master the wisdom of cut and technology from making skirts, and make it right. That is why, the base of the skirt is presented as clearly and definitely (perpendicular to the waist and everything!). If the figure does not have explicit "problems", then such a skirt looks decent and landing is good.
But ... "Any rule has exceptions": the waist line can be higher than the side. This is reflected in the measure: DP (length transition) is greater than dB (side length). In this case, the perpendicular position of the front molding relative to the waist line looks not natural.
Output one - it must be modeled, options can be different.
For example, place the outlet parallel to the middle of the front panel.
To do this, first find the desired position of the middle of the waist line on the waist line, draw the middle line parallel to the middle of the front panel.
Then set aside on both sides to horizontally at half the molding solution and adjust the waistline, connecting points 1 and 2 with points of the beginning of the pullout.
Thus, you equal the sides of the molding.
You can choose any desired inclined position of the middle of the mitigation line, it is modeling, and it is performed in accordance with the laws of visual perception.
Break and transfer of the wretched.
The splitting of the molding is recommended if its solution exceeds 4 cm, the Council has the power for the side and for the front cutting, but more often the problem of "partition" refers to the rear cloth.
To give a specific advice, you need to look at the "relief" of the rear, which form of the buttocks are. Sometimes it is a single bulge, but more often you can see two convex points: one closer to the center, the other is slightly closer to the side seam. If this is your case, then focus on them.
If you have a single convexity, then make a long zy one, and the other is 3 cm in short. Position them, as if around their "peak". In this case, the magnitude of the molding solution (RZ) can be divided into half between two locks.
In the pictures and photos present examples of splitting and their location.
