Sometimes there is a need to connect two PVC pipes, but there is no special clutch and fasteners for this. It is not necessary to despair in such a situation, because there is a simple and very reliable way to fasten such products without using the mentioned accessories. The main advantage of the method is that the purpose of the pipes connected by PVC does not matter.
Fix one of the pipes.
If there was no connecting coupling at hand, it will have to do a fool with a construction dryer. The heat gun softens plastic and will change the shape of one of two pipes. Make it will be able to a person who has even basic handling skills and PVC tubes.
Heat it with a construction hairdryer.
First, with the help of a construction pistol, the end part of one of the pipes is uniformly heated. It is necessary to warm up the region approximately equal to the diameter of the pipe. It should be controlled by the degree of plastic softening: it should lose stiffness, but not melt.
Insert the cold pipe into hot.
When optimal plasticity is achieved, with the help of a construction dryer, this state should be maintained for some time. At this time, the second pipe by the method of longitudinal movement and by rotation at an angle is inserted into the preheated pipe. It is formed by a fuus. When it becomes the approximate diameter of the pipe used, the hairdryer can be turned off.
We form a slurry.
While the pipe cools, it is necessary to continue the formation of the termination. This is done by rotating the second (inserted) pipe in different directions. It is important to apply longitudinal inspiration inside the design. After that, the pipe should be extracted from the termination. Work plots should be cleaned, degreased and lubricate with sealing glue, after which it is born again.
It remains to degrease and lubricate with glue.