The most popular problem of any wires and cables is confused. Even an experienced owner knows how difficult it is to maintain the wires in order, especially if there is no suitable coil. If desired, this thing can be purchased on the market. Where better and more interesting to try to make a suitable coil with your own hands. Fortunately, this is not so difficult, as it may seem at first glance.
Preparatory stage
First of all, you need a canister.
In order to create with your own hands a comfortable coil under the cable, you will need to prepare some materials. First of all, you need an empty canister. A piece of textolite, a bolt M6 (5 cm length), two nuts, a piece of wooden or plastic tube, and a plastic sewer tubing with a connecting field (50 mm diameter) are also useful. In addition, it will be necessary to need superclauses, plug and rubberized outlet, round wire with a cross section of 2.5 mm and 10-15 meters long. From the tools we need a knife, hacksaw (for metal), an electrolovka, a drill with a set of drills and crowns.
The working process
Drill the cover under the wire. /
Working process can be divided into two stages - preparation of parts and assembly. First, in the lid, the canisters need to drill a hole corresponding to the wire diameter. After this, it is necessary to do the coil axis. First, a markup is made from the thick edge of the plastic pipe - 1 cm from the rubber seal.
Making the markup of the pipe.
Preparing handles.
After that, a piece of 5-10 mm is abolished thicker than the canister itself. Cut it with a hacksaw of metal.
From the textolite we make a limiter handle. To do this, we apply our tube as a template and make marking. Cut the blank using the jigsaw. These billets need to do two pieces.
Cut and cleaned, we apply glue.
Cut the hole in the canister.
Similarly, we make two plugs. After they need to be cleaned with the help of sandpaper. If you wish, the resulting details can be painted with aerosol paint. We again take a pipe cut and make a hole for the wire in it. When this is done, you can start collecting the handle. All parts are secure on superclauses for greater reliability.
Collect a handle.
I resemble the wire.
Now is the time to do the center of the canister. Make it easier with two diagonals. We perform the appropriate markup and cut the hole in the center for the coil handle. All remaining irregularities remove the file. The electrical wire is skipped into the handle from the side of the improvised coil and is displayed through the side opening, after which it is started in a canister through the opening under the large edge of the pipe. When it is done, you can insert the coil and fix the superclaim limiters.
Insert the handle and wind the wire.
We collect to the end.
Tighten into the coil the outlet, after which the plug is installed on the other end. The wire is wounded with the help of the handle.