If there is not enough stylish vaz in the house, make them yourself. Hager's fish shows what can be a vase for flowers from a jar or even a glass.
The situation is all familiar when your favorite flowers are sadly hanging over the edge of the vase. High VAZ in the store is full, but a small low vase for short or fading colors is a rarity. Bonus Vase, which is devoted to this master class, in a spectacular holder. Moreover, it will not just "support" your flowers - the magic lid will have to fit both on another glass vessel: for example, you will have a vase from a glass or banks. In a word, a small vase for flowers with your own hands, the photo of which you see below are really useful and really easy!
Flower Vase: Materials and Tools
- Nuts (most often I use the dimensions M5 and M8)
- Superchalter for work on metal
- Simple vase - size and shape choose to your taste, however, as already mentioned, with the same success you can use a low glass or a can of small litter
Step 1
The original flower vase begins with a template that can be created by drawing it around a vase neck on paper. This pattern is needed in order not to make a mistake with the size of the holder of the holder from the nuts: the lid and the vase must come well with each other.
Step 2.
To glue the two nuts with the size of M5, connecting the remaining nuts from different sides to them. Be careful when working with a superclamp: otake the bonded fingers in a few minutes will not be so easy. Therefore, before being taken for glue, shook the workplace with a film or newspaper.
Tip: You can use nuts and other sizes - depending on the thickness of the stems of your favorite colors. M5 is well suited if you have a small vase and flowers with thin stems.
Step 3.
Slowly, but the holder will find a planned shape. Try to get it as flat as possible. But if the nuts appear in height, do not pay attention! You can completely repeat the shape of the template or make a vase holder slightly asymmetric.
In the end, the holder will become large enough to close the vase from above like a lid.
As can be seen in the photo, I decided not to follow the template. But in general, it is better to adhere to it to make sure of the right sizes. Covers holder.
Step 4.
Now use large nuts (M8 size) to create clamps on a donkey vase. They need to be glued in one line. The nuts will act as an additional holder, which will hold the ends of the stems from falling and plenty on the sides of the vessel. Vase from the bank with their own hands is almost ready.
Finish!
Vasuchka and the holder cap from nuts on it will keep flowers in a vertical position and will decorate any interior.
