You can call any thing without which the farm can be done in principle, but its presence makes it easier. It is quite fair this statement and for a pack of packages. You can do without it without it, simply tying or stuck packages. However, if you still have it, you can make a lot of pleasant little things with it. For example, to secure seeds of some plants in a tea bag. It is quite convenient, right?
So why not get such an aggregate, especially if you can do it yourself? You will have to spend on a homemade ship just a little more than one ruble! In addition, this mobile warehouse literally fit on your palm.
![Simple and reliable package shirt with 1 ruble and in just 5 minutes](/userfiles/37/3906_1.webp)
You will need:
- coin;
- a small piece of thick wire;
- lighter;
- a small piece of tin;
- drill;
- instruments
And first it is necessary to prepare a coin, it is it that the soldering element of our device. The coin is perfect for 1 ruble or any similar parameters. The coin needs to find the center. To do this, measure the diameter and fiery several lines. In the center of the coin we turn through the through hole of a small diameter and so far lay it aside.
![Simple and reliable package shirt with 1 ruble and in just 5 minutes](/userfiles/37/3906_2.webp)
On a small piece of tin, we draw the letter H, the distance between the vertical lines should not be greater: in this gap should be placed the coin to the edge. Highly cut the "letter H", the sharp edge is pressed by the passatships, and the shape itself bend in half. Between the two ends of the figure should be placed a coin, and it is necessary that it rotate.
It remains to make the axis for the soldering wheel. To do this, we drill holes in the fastening element. Then we take a small piece of more or less thick wire, its diameter should be slightly less than the diameter of the hole, and we put our design on it. We drive the wire so that it does not fall out and was the axis, too much cutting off.
![Simple and reliable package shirt with 1 ruble and in just 5 minutes](/userfiles/37/3906_3.webp)
The heating element of our mobile sealer is a lighter. At the fastener, we cut the legs a bit so that they had a cone form, and insert it into the slots along the edges of the lighter hole. Shirt is ready! The result he gives the same as the factory wary. It needs to be heated a little, and then spend a soldering wheel at the spike place.
And below you can watch the video on how to make a mobile shipshire with your own hands, as well as a test drive of this homemade.