When sticking wallpapers, places behind the heating radiator are the most complex. There not only narrowly, but also interfere with the brackets on which the battery weighs. For this reason, many just do not glue the wallpaper there, or do it how to get. There is a small trick, how to do everything perfect.
Instruments:
- Mounted knife;
- ruler or square;
- roller;
- curved brush;
- Wide spatula.
The process of sticking wallpaper for the radiator
In order for the wallpaper pattern to be fitted perfectly and came down throughout the room, you need to take care of the open part of the wall above the window. The wallpaper band is glued from the ceiling length to the floor, and then cut over the way. At the bottom of it, it is necessary to appreciate the line of the radiator mounting bracket. Similarly, it is done on the other side of the opening. Under the windowsill between the brackets will remain an open wall.
Then cut a piece of wallpapers with a margin in height for sticking to the remaining pass. It must be applied from above, making it up on the sides of the sides below the wallpaper to combine the drawing. Further, there are notches in front of the brackets.
On notches are made even cuts with a mounting knife for a ruler before the start of the brackets. After that, the place of sticking is missing by the wallpaper glue, this can be passed on the battery only with a curved brush.
Wallpapers are inserted over the battery side under fasteners, then straighten and output upwards. After the stop in the brackets you need to deploy socidors and smooth them over the radiator to the windowsill. The entire wallpaper plane is pressed. There is a brush between the ribs of the radiator.
Excess band height is cut with a knife. Next, you need to lubricate the wallpaper in the place of overweight and stay on top of the second layer. After that, trimming on the brackets is made.
The last step is the vertical trimming of overlaps. This is done on the edge of the spatula blades. The cut is performed opposite the edges of the extreme battery sections. This will allow you to visually hide failure in the wallpaper drawing if it turned out. Then the carved strips break, glue is applied on the wall again, and the edges are not allowed.
As a result, we get a very high-quality fit. The impression will be created that for sticking wallpapers, the battery was simply starred.
