We take the rope.
What do you need : 2.5 meters thick rope, piece of cardboard, tape, lighter, scissors
IMPORTANT : Before you take to work with a handle, you need to maximize the blade of the knife. To do this, you can first remove the tool from the case, and then close the blade with a cardboard, thoroughly having taken it to the knife using a tape.
There is nothing complicated.
We take a cooked rope and bend it in half. After that, we start it from the top of the handle. Tie a node. Now we press the rope to the place where the surveillance will be made. It is very important to ensure that the rope does not crawl during the work. To do this, you need to constantly correct the rope design.
We start knitting.
After the first node is ready for one side of the handle, the second is made below. For each node, the tie procedure is the same. After the formation of a new node, the rope must be tightened as close as possible and corrected. The formation of nodes continues until the rope covers the entire handle. For this reason, it should be taken with a margin.
Constantly pull up.
After the woven handle comes to the very end, unnecessary rope ends should be cut, leaving about 5 mm on each side. Flusted ends are mandatory migrated and melt. It should be traced that the rope does not catch up. While the polymer does not have time to cool, you need to have time to press it to the last turn of the finished winding.
The whole process of forming the handle can be seen in the video material.
