Everything happens in life. May come to the day when you need to screw into the usual cartridge lamp with a thin basement. Each owner with chord will say that it is impossible for objective technical reasons. And in general will be right. However, "but" in this issue is that with a truly urgent need you can go on one curious trick.
We take out the base.
So, we will imagine that we need to screw the light bulb with the E14 base in the E27 patron. How can I do that? The question is good, but it has a fairly simple answer. It is necessary to immediately make a reservation that this technique should be resorted only in emergency situations where the output from the situation must be found in a short period of time. To implement the "Project" you will need a lamp E27. Carefully deal with its flask and also carefully remove its contents.
Cut from tin blank.
Using suitable tools, we remove contacts and isolation. After that, we take measurement tools and measure the diameter of the E14 base. Now we take a piece of tin (you can cut some empty canister) and make a hole in it under our base. After that, exactly also measure the diameter of the E27 and make the markup around the hole.
Make such a thing.
Following the cutting circle with the hole. It will invest in our big diameter cartridge. For the reliability of the connection, the design is recommended to be sought. After that, it remains only delicately and unheard to screw the lamp with a smaller cartridge. If everything was done correctly, then it will be very firmly held. It remains only to connect the system to the network and check its performance.
That's ready.