Nowadays, chipboard is a widespread material. It is from it that the lion's share of furniture is made, which is used in the household. Therefore, there is nothing surprising that citizens regularly face a variety of problems, one way or another associated with violation of the integrity of the chipboard. Given all this, it is important to know how the restoration of this material is carried out.
The chipboard is that and it breaks.
As you know, the chipboard is significantly inferior to the strength of the usual tree. However, this material is used at all because of its strength, but due to the wide availability and low cost. DSP defects are usually a matter. Sooner or later, each owner faces damage from this material. On the other hand, restored the chipboard is not so difficult, including using undergraduates. There are different techniques, however, today I would like to stay on one on the example of the recovery of the corner.
It will take glue.
It should be noted immediately note that damage to the corners of the chipboard is one of the most "nasty" breakdowns. Restore the defect in the middle of the material is much easier. The edges and corners of the boards do not possess such a margin of strength and potential for recovery. So, for the restoration, the cyanacrylate second-hand cyanacrycrylate adhesive is required, as well as dust from grinding (best oak).
Still need dust and sawdust.
Note : glue must be liquid, not as a gel.
The process of restoring the angle actually does not at least any complexity. First we take the greasy tape and make a "formwork" from it around the whole plot. To cry, pulling the tape too much, in no case is not necessary. The new angle should be slightly larger. This is necessary so that after the first stage of restoration it could be calmly handled.
We make from Scotch here.
Swamp the surface of the damaged section by glue. After that, we fall asleep to the place of restoration of oak dust and sawdust, pour some little glue and carefully tamper. It is important to ensure that the mass is obtained as dense as possible. If necessary, add some more "raw materials" and glue. We continue to the victorious end, then we are waiting for 5-10 minutes until the design is driving.
Fruits of Labor.
When the recovered angle will dry up, it will remain only armed with a file and emery paper, and then put it in order to remove everything too much. That's all the technology.