Laying tiles is far from the simplest thing that can delay in long hours, but in some cases even days. The experienced master and the owner will always be happy not only for the quality of the made, but also for the speed of completing the task. That is why when working with tiles, it is worth spending some time to create the simplest device that will accelerate the process almost twice.
Assembly process
Preparing materials.
So, for the manufacture of fixtures for masonry tiles, you need to prepare a pair of rectangular wood bars and a sheet of chipboard. Bruks should be cut into 4 equal segments (approximately 30 cm). This can be done including ordinary hacksaw. When it is done, the segments are attached to the chipboard.
Measurements are made using tiles.
It is best to do this with the help of self-tapping screws. To do this, it is also recommended to drill fastening holes on 2/3 lengths in the bars. The diameter of the hole must coincide with the diameter of the hats of a methome.
Collect completely.
Now put one tile on the sheet of chipboard, and on the sides of it we put two bar. It is necessary to make sure that the tile lay is tight enough, but still could move. We collect the design. It is very important to make it so that you can install a toothed spatula for applying glue into the gap between the slats. That is, in fact, the entire assembly procedure.
Install the blade.
How to use
We start using.
It is not difficult to use the tool. Having collected the entire design, it is necessary to impose adhesive in the device. After that, the tile is inserted into the tool and pushed under the glue forward. As a result, it will be released, on the other hand, from a spatula with glue printed over the entire length. The main thing is that this tool is good, so this is the fact that the glue is applied to the tile as evenly possible.