The usual medical syringe is an extremely useful thing in the farm, especially when it comes to performing any repair work. Finding ways to use this simple thing can be born. Consider some of the most practical and often implemented in the practice of advice, which will be able to significantly alleviate the repair process in the most unexpected trifles.
1. Applying sealant
First of all, the syringe can be used to apply sealant. Especially useful in this regard when working with joints (in places connect pipes and other surfaces). If necessary, you can cut a cotton wand from two ends and make a nozzle for a syringe from it. It should be attached to glue, for funny reliability. If you need a larger diameter, then you can make a nozzle from the rod ballpoint or flexible tube (straw).
2. Lubrication mechanisms
It is clear that the syringe can be easily used to lubricate mechanisms. The most important thing is that the spout of the syringe can crawl into any, even the most hard-to-reach place. Moreover, you can always add a needham syringe that will allow you to even more expand its functionality.
3. Storage of glue
The adhesive can be stored in the syringe. So the solution will actually be much more comfortable and practical than to store glue in a small tube. You can drag the material using a conventional needle. As a rule, the consistency of glue allows such manipulation without any complications. In addition, subsequently serve glue from the syringe is much more convenient than to serve it from the tube.
4. Elimination of bubbles on the wallpaper
Bubbles on the wallpaper are easily removed using a syringe with a needle, glue and one more needle. First we do in the bubble a small hole for air outlet. After that, we gain glue into the syringe and, put on it with a needle, carefully focus it to a bubble through the seam. We enter the adhesive substance and recall the bubble. If everything was done correctly, the wallpaper will be perfectly smooth again.
5. Removal of Exclosk
Very often, in the process of performing certain works, it turns out that in the slot or on the surface of the material there are excess glue, oil or any other similar fluid. If it is inactively erased the composition, then it may be difficult to remove the separated divorces. Where better (and more correctly) collect surplus with a syringe. Just get their composition and now everything is completely clean.