Before proceeding with the creation of lilac, I studied the "live instance".
The building at the twig is very interesting. The approximate location of the flowerkets is in the diagram.
Let's start with the creation of flowers. In order for lilac looks more gentle and air, it is better to use two layers for a flower: it is a pearl matte and translucent two shades - pink from the "Fruto Nanny" and lilac from mineral water.
Preparations will be three types:
- Five petals - in every lilac branch simply must be a happy flower of five petals. :)
- Four petals - pearl layer of blurred flowers.
- Three petals - for boutons and translucent layer
Four petals
Cut plastic per squares 1.5 mm. Cut every side in half, leaving in the center about 5 mm. You will have 4 petals. Lightly round each from above and around the edges.
For a five-point flower from a square cut a pentagon. Three petals - cut the triangle. Hereinafter, just like with four-fledged.
When all the blanks are prepared, go to heat treatment.
Important - when working with plastic, the room should be ventilated. The billet is better to keep the rounds. Processing is not carried out on fire, but above, that is, on the hot air. The candles should be on the billet to the blank should be at least 2 cm, otherwise the plastic will darken and bakes.
The workpiece to bring to the candle by the convex side up, each petal in turns literally for seconds, and immediately remove.
Thus, we proceed all the blanks.
And now we start assembling lilac sprigs. It will take: a wire thickness of 0.4mm, beads, glass, beads, droplets for buds.
Cut 2 m wires, type beads, fold in half, type the droplet beads on two ends of the wire and the glass for any one end of the wire.
Tighten. And twist a little.
The first "tier" consists of three branches with closed bead buds.
Take one end of the wire, type the glass on it, beads, beads and swipe the wire back through the bead, the beads is a fixer.
Twist another twig. And one more. And now twist all three, 5mm down.
The next tier consists of two twigs of three branches - one bud - a bead and two semi-scratched buds.
Take the long end of the wire and twist another twig. And one more, adding a bouton instead of a bead. Twist.
Add one more branch twig.
Twice down another 5-7mm. Add one more twig from two buds and beads.
Twill down to 10mm down again.
The following branches are made by adding flowers according to the scheme. Flowers are gradually revealed, add quadruple and four-fledged with a transparent three-fledged layer.
The third tier is two branches of 5 flower branches.
Before each tier twist the wire down by 10 mm.
For each tier, add two branches with flowers. The fourth tier - 7, the fifth tier - 9 and so on, until you arrive the length of the twig. In nature, each twig of lilac is usually 7-9 tiers.
If the wire length is over, it can be easily increasing. Cut more 1.5 - 2 m, fold in half and wrap around the extreme twig, continue to weave the branch, periodically winding around the tips of the previous wire.
This is what should happen about. Spread the sprigs-flowers.
Such a twig can be fixed on brooches, hairpins and even weed in a bracelet or necklace.
A source