Sometimes at hand, there are so uncompatible things that they just have a diva. Is it possible to do some of them? It turns out yes!
Hello everyone, with you again Nyaskory! Today I came across a very cute thing that I had the opportunity to create a couple of years ago. And I did it out of the box from the purse, a car liner and a pair of fabric species.
Small prehistory. A few years ago, I had a boom shopping jewelry with Ali (mostly earrings). Now I almost do not use decorations, but then the main joy was the acquisition of another bauble for the ears. And they have been accumulated so much ... In general, there is a need for a well-structured casket. I defeat the city of city, I realized that I could not find a decent volume of the storage. I had to do :)
The process of creating a spacious box
After attaching your own capabilities and knowledge of the needlework at that time, I acquired the following materials (something already happened):
- Purse box;
- foam sponge with a rigid face (as for washing dishes, only more);
- Thin white cloth for tosing foam-foam separators;
- Fleece for the outside (you can take any cloth that likes);
- threads, scissors, knife, glue;
- Two small wooden sticks to strengthen the edges;
- A bit of rolled syntheps (optional).
I did not cultivate the lower part of the box, as it was so pretty enough.
First of all, you will need to cut a sponge. I have a photo of the process, unfortunately, it is not left, but the point is that there should be a rigid side at the top of each strip.
The height of each section should be slightly lower than the height of the box, the length is equal to the length of the inner part of the box, and the width is arbitrary.
The number of strips is also at your discretion - it is not necessary to fill the box closely.
It is better to make the width of at least a centimeter of one and a half. I then famered and now use the casket is not always convenient - not all the earrings fit.
Each of the strips should be covered with a cloth (in theory it is not necessary, but the box will last longer and it will look more careful). Take the same cloth and wooden holders (seen in the photo, they are on the sides).
Now all strips place inside the casket and press the holders, melted glue on top. No additional fasteners will need.
It remains to cover the lid with the cloth and add decorative elements.
I tightened the lid with a raspberry fleece, firing the cover on the fabric to get a blank, which can be pulled and on the side parts too.
Approximate type of sweep.
Inside, I almost did not leave the tissue stock - gently glued it around the edge.
Under the fleece, I put a piece of synthesis to get a softer box.
This is how the final version of the lid looks like. You can take any decorative elements (artificial flowers, stripes, etc.)
I have everything on this. I hope that you liked the box :)