Today I want to show one small trick that can help out the situation and save time.
Sometimes it happens that it is necessary to see the finishing line with thick thread, and so does not turn out to be at hand. You can take two coils of threads of thorough and strain, connecting the threads. And if the coil is alone? We'll have to spend a lot of time, unwinding it on separate bobbs. In this case, you can not guess with a length (well, if it remains). And you can take one coil and shoot the desired line to the desired length.
So, we take the coil of the thread. I specifically picked up.
We put out of two threads loop. Length can be arbitrary, I did so that it fit into the lens.
Third thread, holding for the tip, leading to the resulting loop.
Take it in such a way that I got a loop, pulling for which we get three threads again from the loop at the end.
The length at this stage should be such that it can be winding it onto the coil and insert into the machine. Approximately 1m.
Strict.
During the work, this picture is obtained.
Now in the process of the line, we can, pulling the loops on the desired length, stop the product.
The main thing is not to sleep and on time to tighten the threads on time. So, as the needles of the relevant number, the joints of the corresponding number are used, the joints of the threads are used without problems without problems and it does not reflect on the stitching. This is such a line turns out.
This technique I showed me a shield in the atelier many years ago. I recently read a master class, where it was used in knitting. I hope my experience will come in handy.
Thanks for attention.
A source