It happens that quite sad things come with furniture, which bring an unpleasant precipitate and sometimes entail considerable financial costs! Speech in this article will go about "extended" with the root of the hinges of the facade from the cabinet case. No matter if it is a kitchen set, an entrance hall or any other cabinet, this trouble may happen regardless of the type of furniture ...
If you have this happened, do not hurry to call the masters, you can easily correct everything yourself.Consider this situation on my example. It happened to the top cabinet cheap kitchen headset.
The reasons may be different, but my assumption is still not high-quality material of the LDSP.
Okay, the trouble occurred and it must be fixed somehow.
Initially, we dismantle the door and remove the mounting planks from the loops from it, it will be much more convenient to work.
For repair, we will need to make a kind of putty. To make it use only two components, these are sawdust and glue.
Sawdust is better to use fine fractions. The smaller they will, the more dense it will turn out, and subsequently will be better to hold. At hand, I had only a small piece of LDSP. To get the sawdust, I had to "set out" a bit. After some kind of sawdust need to be crushed ...
Next we will need such a glue! Mark I think you know. So there was no reproaches that this is an advertisement, the manufacturer I specifically hid =). This glue is very thick, it has good adhesion to the materials, it is relatively quickly grasped. After the frozen, it is very firmly held.Now it is necessary to take a small container and mix in it putty. I from somewhere found a rare jar from the film =). The ratio determine the eye, the mixture should be with a sufficient amount of glue, consistency as a conventional factory putty on a tree (maybe a little bit).
Quickly fill the putty formed in the housing of the hole! Prettyly increasing the mixture into the deeder, after which they pour with a spatula.
If the excess glue fell to the surface of the LDSP, they must be carefully removed with a wet sponge.
We leave to complete drying according to the instructions on the glue. After the putty dried, it is necessary to give furniture a little aesthetically pleasant look. In this we will help the wax chalk in the color of LDSP. We rub the frozen putty, you take off the spatula too much. It remains only to fasten the loop into place, the holes for the screw of 16mm are weltering. You need to pick up, do not skip this stage! Also, in order to strengthen the design, screwed the self-tapping screw in the middle of the loop, 19 mm long. For more strength, the self-tapping screw was lubricated with the same glue! This is the result! Defects are absolutely not visible. The door is perfectly held and fully used!