Often, buying jeans, we are faced with the need to shorten the length. At the same time, I do not want to lose the factory seam - after all, the bottom of the trousers often decorate an unusual finishing line or rubbing.
YOU WILL NEED:
- jeans
- scissors
- Pins
- Rule
- iron
- sewing machine
- Thicks
STEP 1
Determine the desired length of jeans and tick the new line of the bottom of the portno small or pins.Step 2.
Align a new niza line with a finishing line.
From the wrong side you will have a fold.
With the help of the line, align the fold so that the distance from the factory bending to the new line of the Niza was the same and pinched into the pins.
Step 3.
Route the line as close as possible to the factory bending niza.
Please note: the side and inner seams must be combined as soon as possible, otherwise the bottom of the product will look ugly and inactively!
Step 4.
Cut the fold, leaving the allowance of 1-1.5 cm. Drink the edge of the passage on a overlock or a zigzag lines on a typewriter.
Step 5.
It remains to unscrew the bending down, and the allowance will be used up. Package Fasten the finishing line into the seam or sylow at a distance of 1-2 mm from the seam of threads to the tone of jeans or contrasting - depending on your desire.
In the same way, you can also be used and velvet trousers.
Measure the desired length, we combine a new line of niza with a finishing line, align the bending, lay the line close to the edge of the factory bending, cut and clean the allowance.
We turn out, start the allowance up and fix the finishing line in the seam (if you want it to be seen) or at a distance of 1-2 mm from the seam.
Room and ready!
A source