Today I want to tell you about some tricks, home billets, devices that used and seed the day use in their arsenal experienced repairmen.
1. When you need to make a through hole in the wood better drill it on both sides, so that there was no such disgrace.
In addition, the drill in can go to the side and to avoid it, it is worth using a template, especially if the hole must be drilled at a certain angle. What to do if the desired template is not at hand? True, make it yourself.
We take the bar of the length of the centimeters 12-15 and we make a smooth longitudinal through hole in it. Then with the help of a machine or stouch cut off the workpiece under the required angle and the template is ready.
2. Some drills and screwdrivers are not intended for very thin drills, what to do in this situation?
And the output is simple, you can wind the base of the drill with a soft stranded copper wire, and the cartridge will be heated.
3. If you drill iron and do not want to collect chips all over the floor, take the magnet, wrap it into paper and put next to the drill, the magnet will attract all chips, and the paper will allow them to remove them without problems with the magnet.
4. How to find out the diameter of the pipe or drill, if the marking is erased, but there is no caliper, well, would you get lost? It can be made by a separate key and tape measure or ruler. Cleash the drill in the adjustable key, then with a roulette measuring the distance - ready. Elementary!
Source ➝