Hi friends! Today's topic: how to make a chest with your own hands or when your girl is a little pirate. =)
Materials necessary for the manufacture of chest:
- 65 mm wide width. (2x110 mm, 2x70 mm, 1x130 mm);
- plywood sheet 3 mm thick.;
- Metal sheet;
- Copper wire 2 and 2.5 mm.;
- Little loops;
- Morida color rosewood;
- carnations;
- sandpaper;
- red velvet paper;
- PVA glue;
- Glue for the trim.
Tool required for the manufacture of chest:
- a hammer;
- wood hacksaw;
- Brush crash on wood;
- burner;
- triangular cutter;
- clamp;
- pliers;
- Circumgars.
It is nearing March 8 and you need to think something to do to him. Such such pieces have remained.
Of these, we will do anything. Cut the pieces, the width turned 65 mm. Cut 2 sections of 110 mm. Long, 2 to 70 mm. and 1 long 130 mm. To come from us, something that is.
We will make the chest, the casket, which will turn into shorter. Little, but I hope that the pretty! Glue we have PVA, we will glue them. Clamps fix the combined design. The main thing is to put it all correctly, because when it sticks, it will be too late to change something.
Leave to dry out. While our chest will dry, we will deal with everyone else. For the beginning we take copper wire, in my case it is 2.5 mm. We will make handles from her for our chest. We make bend.
Of 2 mm. Copper wire with the help of round bubbles make a loop for our chest knobs. We need 4 pcs such loops.
Cut the iron strip of 10 mm.
We comply with our chests. We make our top cover a little semicircular.
Corners remove under 45 degrees. Remove from all four sides.
We carry out a line every 10 mm., Then we pass on the tops of the triangular cutter.
It turned out something like that
We do the same from all sides, including the lid.
We need that the cover would be opened accordingly, since this is a chest. Well, it means you need to do it. We heat up the top of the hacksaw.
When everything is unpacked, we can then not be afraid that there will be problems with the paddling of gaps, etc.
We take our metal stripes and envelope on the lid. Next, the verse covered our chest.
It seems to me the chest is high, so I decided to cut 1 cm. Now the total height is 65 mm. The bottom of the chest is made of 3 mm. plywood.
The velvet red paper is glued to the cardboard with the help of car glue for the trim.
Check cover fix on small loops.
As a result, I got such a chest with my own hands.
Detailed process manufacturing chest look in my video. Friends, subscribe to the channel not to miss new videos.