During self-insulation, which now has absorbed the whole world, free time is released. He wants to spend with benefit. You begin to remember ideas that I have long wanted to implement, but for which there was not enough time. So, time has come!
In anticipation of the summer, the opening of the seasons of hunting, fishing and just campaigns in the forest, there was a desire to make a wonderful homemade in the form of an alcohol burner. Honestly, the idea is not new, but perhaps not everyone knows about it.
Therefore, in this publication, I will show how the alcohol burner has made, more for the soul (balobiness) and in order to occupy the younger generation during self-insulation. The boys like everything burning, explodes, collapsed ... Such is a male essence. So take a note, at least in order to take the children =).
So let's go!
We will need two identical aluminum banks and glass salas.Banks are needed to create a burner housing, and glassmate (glass resistant) I decided to use to increase the area of evaporation of alcohol and exclude alcohol spilling in the case of tipping the burner.
We mark the size you need to cut off. I did about 3-4 centimeters, I consider this size optimal.
Best cut with scissors, because The stationery knife is not so smoothly, the edges may be pregnant. Cutting both banks, two identical halves are obtained.Cut the fiberglass strips, the width of equal to the height of your burner.
Next, the strips twist into the roll.We place the roll into the lower part of the burner. It turns out like this:Connect halves.
Clean the sharp edges of sandpaper.
In order not to emerge evaporation from those places where "not needed," blelled the joint aluminum scotch.Further, around the circle you need to make holes, they are nozzles. And one hole in the middle for refueling the burner. Choosing a screws to this hole to close the hole after refueling them.
All this made a sewer from the set to replace the sealing rings. This set has different hooks which is very convenient to work. Such as I can't sell on Ali, I bought it for a long time.
It remains only to test.How it works?
The whole point is to launch the process of evaporation of alcohol. After the alcohol pair begin to go out through the holes, at the same time igniting, the burner will already maintain the combustion mode until the alcohol is over.
So here. To start the evaporation process, it is necessary to initially heat the burner.
Options are actually two:
1. It's with help lighter will wait until the case does not warm up. 2. It is to put under the burner with a metal cover, drop there a little alcohol and set fire. In this case, the burner is quickly warming up and goes to mode.For the experiment, I hit the housing using my favorite gas soldering iron and launched the burner burning process. Great thing
It burns well, just slightly moved with the diameter of the openings of work injectors. The flame turned out to be greasy that it would be bad for fuel economy.