We will need:
- Beads of different shades for multicolored bells. You can take one-photo, but it must be fine enough (no more than 2 mm). Green is needed for leaves.
- Special thin wire for beadwork №3 or №4.
- Small nippers.
- Tweezers.
- Floral tape or (with its absence) Muline of a beautiful green and PVA glue - it will be needed for processing stalks. Beautiful flower pot or miniature vase.
We begin to weave the petal
To do this, we take a longer segment of the wire. We are wearing a bell from beads according to this scheme of the sewer's weaving - you first type one beerin, as shown in the figure. For the purpose of the whole petal of nineteen rows we relate, tightening the wire after each row.
The second petal should be attached to the first at the level of 11-12 rows. The following petals are wearing and connected with finished petals in a similar way.
In total, there will be five petals in the flower. The fifth connects with the first, after that the free ends of the wire should be lowered down and twisted the stem from them.
Attaching the stamens and forming a flower head
Stychkin
Cut a piece of wire with a length of about 30 cm. And we ride from 15 to 20 bisperin of a light shade. Their amount is approximate, since the bead size may differ slightly. For greater accuracy, it should be noted that the length of the entire segment must be 3 cm. Calculate how much the beads have come out and remember this amount. Now turn the groaned beads into the loop and twist the wire. Then follow two more such loops. The resulting "rings" should be accurately stretched, having received the similarity of the bud. This will be stamens. To form them, twist the remaining wire into the stem.
In the finished flower insert the stamens. If they are "lacking" along the length, simply add beery to the free end of the wire.
We proceed with the set of leaves for each bell beads. We ride the following cutter and weeping a green leaf according to the scheme 1-2-3-3-2-1, they need 5 pieces. When all 5 pieces are scored, we dress them on the flower. We form them, and the end of the wire twist with the main stem.
We make "leaves"
It is very simple to make them: We recruit the beads, as shown in the figure and independently adjust the desired length. For our bell, there are enough two or three leaves.
Wire ends twist with the main stem, connecting leaves.
Stem winds up with a floristic ribbon, trying to do it very carefully. In principle, it can be replaced with Moulin, moistened in PVA. But this is more painstaking work. Some masters do not use glue at all and cost only threads. Choose what you are more convenient.
Repeat steps with a bead of another color, make a whole bouquet of bead colors and put them in a vase.