The bull made by the origami modules put on the trousers and cap of red, because she gathered on the New Year's Christmas tree. Pants bull can be made in any color.
1. Prepare for the first three rows of 90 red modules (3x30). Collect three rows at the same time. Close the chain into the ring, remove it and pave four more rows of 30 red modules in each.
2. Next, that is, the eighth row run out of 30 black modules.
3. In the ranks from the ninth to the twelfth, also fasten up 30 modules. Bull torso - white with two black pepids. To lay out them, use 11 and 7 black modules. Plots may have an arbitrary shape.
4. The thirteenth row is the last for the body. It must be reduced by 4 modules. To do this, in four places, wear a pair of neighboring modules not at 4 corners, but by 6. When the torso is completed, give it a rounded shape, carefully naked with his finger on the workpiece from the inside.
5. The first row of the head consists of 26 white modules. Wear them with short sides to the very tips of the last row of the body.
6. Perform another eight rows of 26 modules, putting on the modules with long sides outward. On the head of the bull need to lay out two uneven spots, each of the 9 black modules.
7. When the head is ready, give it a spherical shape. The modules of the last row are so twisted with each other so that the minimum hole remains above.
8. Prepare 14 white and 2 black modules for each handle. Place 3 white modules as shown on (photo 8). The module on the right will be the first row, the modules on the left - the second. Connect the modules to each other.
9. Perform the third row of nave 1 white module on the internal corners of the second row modules (photo 9).
10 . In the fourth row, the top-pit 2 modules using all 4 protruding corners (photo 10).
11. Continue in the same order until nine rows get.
12. In the tenth row, fasten 2 black modules (hoofs) (photo 12).
13. Insert the connecting module as shown (photo 13).
fourteen . The second handle is performed in the same way. At the end of the assembly it must be a little bend. To make a bull be friendly to wave, the connecting module must be inserted differently, the angle down (photo 14).
fifteen . The feet of the bull are collected in the same way as the handles, but instead of white modules are used red.
sixteen . Get ready-made legs and turn over. Connecting modules Bend in half (photo 16).
17. Insert the connecting modules as shown (photo 17).
eighteen . To attach the leg, carefully shove the corner of the connecting module between the halves of the selected module in the fourth row of the body. Handles attach to the last row of the body (photo 18).
19. Make a horn and ears from a dense paper, from fine - bangs. Draw and cut the face and eyes. You can sew a bull New Year's hat and hang a small bell on the neck (photo 19).
A source: Klubokdel.ru.