Each owner or hostess at least once had to face such an unpleasant phenomenon like a bloating tree. For example, such often happens with various shelves and countertops, which was spilled water, which was able to get under the protective coating. In addition, the swelling of the material very often happens when the tabletop installation was incorrect.
Wood-chipboard is the material available enough, but at the same time and very whimsical. In an unprotected form, he quickly absorbs moisture in large quantities. Profile of chipboard, which was not protected in the kitchen with laminated coating, is doomed to bloating. In addition, the negative reaction can cover the product if the protective cover was damaged or incorrectly made at the production stage. Also, some masters forget that all unprotected sides of the DSP profile must be covered with sealant during operation. Most often, the incorrectly made countertop in the kitchen swells precisely in the joints of the joints.
Repair of products from chipboard, especially kitchen furniture, can fly the owner into a serious penny. But you can try to eliminate the swelling of the material with your own hands. For work, first of all, you will need a hairdryer. Even the usual household has come true. With it, it is necessary to dry well dry material, thereby removing from it all moisture. Sew should be about 10 minutes. However, in the launched cases, drying may require a period of more than one hour.
As soon as the moisture is removed from the material, you can proceed to the removal of irregularities. To do this, it is necessary to carry out partial cutting and drill material from the inside of the table top. According to the results of the work inside the chipboard, emptiness should be formed. They poured the prepared mixture of wood sawdust and PVA glue - "Liquid Tree".
As soon as the emptiness is filled, on top and bottom of the table top, it is necessary to secure two plates. Best is wooden or metal. They are squeezed among themselves through a restored board using clamping clamps. In this position, the whole design remains in a state of resting at least 2-3 hours. The final stage of the work will be covered with unprotected parts of the DSP sealant profile. We also recommend purchasing metal or plastic plates on the construction market and corners to protect worktops. They sit on ordinary screws.