A year ago, when exchanging a cylinder at the gas station, I discarded one balloon. It was possible to pay for that, but I did not, because I have 3 more cylinders. And what to do with the old cylinder, I did not even think about it.
I have 2 mangals in my operation. And years they already, if the memory does not change, 25. But no matter how metal on them, they have already rusted in the corners. And in general, they have not satisfied me anymore. There are no flexibility in cooking. And here is almost free cylinder. And immediately decided to make a thing from him!
Last summer saw the valve, drilled the hole in the bottom and poured with water. The valve cut off with a metal with a metal, watering the place of cruel. The balloon was to the old one that the valve was standing on it. The hole drill is also very careful, on small turns and constantly watering the water drill. All autumn a cylinder stood with water, and for the winter I merged her.
So, we have a balloon. Put it on the stand for processing timber. Cut off the hoop stand, stated and made 2 reces on the loop and facial line. From the sides have not yet cut. I cleaned the paint around the places of welding. On the street periodic rains. Therefore, in the garage it was imposed on floor slices of fiberboard and plywood. I have it specifically for welding. It was pregnant that the sparks would not fly where it fell. The loop, which on the business was bought in advance. From pruning prof. Pipes 15x15 made a handle, welded and put it on the street. I stated the side cuts and cutting. Opened the lid no longer a cylinder, but the future mangala grill.
And here I noticed that I gave Mahu. T. K. For the first time I do this work, it turned out that, together with the metal metal, the hoop, which was fell under the seam when assembling a balloon. I had to walked and breed this extra cut from the inside of the balloon. But it turned out, the truth had to swim.
Left:
- Private the cover opening limiter so that it does not fall at full opening.
- to welcome the strip around the cover to smoke in the barbecue position, preferably, did not run through the slots,
- construct a pipe with a valve,
- weld the stand with wheels and tables,
- burn from the inside,
- Clean the burnt paint outside,
- paint paint to 1000 ° C,
- And on trifles, such as a stand under the skewer and grill grill, etc. T. e. There are not much left.
I did all this, judging by the photo. I have done all this work in the spring and summer of 2017. And since then, my barbecue is in great demand. Because I live in my house, then we often often with my wife, without reason, cook meat, cutlets, wings, fish, vegetables on my device. Ask, I will answer.
By the way, the mystery. What is my pipe on the cylinder?
Further manufacturing process of mangala barbecue:
