This way you can embroider the volumetric flowers, in which each petal will lie separately above the fabric surface. You can still take advantage of them, for example, to embroider the volumetric ears with some kind of little animal. Petals can be done big, and smaller. Threads are better to take non-novel, volumetric. However, if you want to make very small elegant petals, you can try to work with thin threads.
You will need:
- Threads for embroidery;- needle for embroidery;
- the cloth;
- Pickles;
- Portnovo pin;
- Scissors.
STEP 1
The fabric refuel into the hoop. The thread is inhabited in the needle, we make a nodule, we leave it on the wrongness, the needle takes it where the lower edge of the petal will be.
Take the Portnovo pin. With it, we will form a support for weaving the petal and set it up. Plug so that the head remains with the front side, and the pin herself entered the cloth where the sharp tip of the petal will be. From the inside, output the tip on the front side where the middle of the wide end of the petal is planned. Then hide the sharp end of the pin, removing it on the wrong side.
Thread start the pin and remove down.
The needle with the thread stick to where the second edge of the wide part of the petal is planned. The book will be in the middle. Display the thread from the inside close to the pin.
Thread again get behind the pin head. The basis for weaving the petal is ready.
Step 2.
We begin to weave the petal. Skip the end of the needle, fashioning threads through one (we all stretched 3 threads).
Tension thread. The tip of the petal will be narrow, so on the first row of weaving a thread must be pulled out.
The second row of weaving is starting from the side where the first was completed. Find out the threads in a chess order relative to the first row, as with weaving. Tighten the thread in the second row less than in the first.
Repeat in the same order and further. Seal layers of threads with a needle. While you do not reach the middle, you can make a petal sewing, weakening the tension of the thread. After the middle, you can start to narrow the petal, again tightening the thread stronger.
Step 3.
Having reached the end of the petal, output the thread inside out and remove the pin. Now you can start a new petal.
If there are such petals in a circle, it turns out a volumetric flower.
Ready.
