From the wild cat! In the topic considered already, about the thermal mode of the computer, we found out that the cooling, your computer does not prevent. Especially, in the anticipation of the upcoming summer, with its unpredictable temperatures. The theory is good - practice is better! As for theory, go to practice. We open your "drawer" and think about how to improve it (thermal mode). As a rule, there are several fans to provide cooling. In BP, on the CPU, the video card, well, the additional ones are on the housing. As a rule, the manufacturer is limited to the required minimum. And we want a maximum! And if we can allow us to work with handles .... Consider a typical "drawer":
As you see, everything seems to eat, and even the input and output fans on the housing providing ventilating "in the tunnel". But reserves are still available. Suppose "on the roof" it is quite possible to install an additional fan. But I did not do this yet, since I have a sabbufer "on the roof".
Prepare something from "unnecessary":
And proceed to work that will take a maximum of the day (with big breaks). Remove the lateral lid. Of the further I think everything will become clear:
In the mine we put additional ones (follow the direction of blowing).
We determine the place where it is possible to put additional. That's where it was found. Let the vidyuhu blowing ....
Location and breathe the necessary holes.
We put the grid and fan.
From the wall from the BP cut out:
And we put on a screw without forgetting about the washers (laying 1 cm.).
Of course you can make it easier, but in this case the fan works on suction and you need to filter the air from dust.
Here in the context of approximately so.
You need to add that another suction on this "box" in front and equipped with a mesh. But !!!
LIKE THIS. 2 new fans are installed. From the housing is made by the extension of the air "Tunnel". Schematically so somewhere:
Result:
Well, in the end - food! All (except processor) fans are powered by a separate power supply.
In order not to load the main BP.
The connection of such (additional BP) has already written. Well, at the end of the topic, it remains to add that the radiators "lying" on the table is not in vain! Perhaps their fixture on standard:
Only it is necessary to make extremely neatly! In some cases, it is necessary to drill a chute to drill the main radiator. The main thing is not to get involved, and do not drill the processor with the motherboard! Well, if you still drill, - not trouble !!! Take the hole then more and hang on the wall on a nail. Will be as an interior decoration! Thanks for attention! Cocking your computers!