To begin with, we post our wealth (beads and beads) and look at how it all combines, then we spend on some container and how they all mix. So, the beginning is allowed!
Then all this mix is rushing on the line. I ride everything at once, well, I do not like to donanize.
When everyone was riveted, we leave a small piece of the fishing line about 50-70 cm and begin to knit the simplest chain of air loops. The first 2-3 hinges I check without beads, then I will put the beerink to the hook and tie the air loop and so on.
What is important at this stage? Do not pull off the loops, try to lie freely. Before and after large beads and beads, I check 2-3 empty air loops. You can periodically in the process of knitting such a chain to leave loops without beads and beads for greater "airiness". That's what we get:
When we accumulated the entire risen mix, close the last loop, cut off the line 50-70 cm long and so far we are postponed. Can you drink a cup of tea, a cup of juice or can something stronger? In general, we will arrange a small break now we will begin drawing, or rather the draw. Yes, yes, I was not mistaken! We take something big and tight so that you can stick pin. In my case, I took the old box, laid it out and painted such a trapecy.
The size of the trapezium depends directly from what you want to get in the final. If you assume to make the air to the level of the neckline, then approximate dimensions of 35 per 50 cm, if the necklace is clearly around the neck, the size of approximately 40-42 by 50 cm. The number of threads in the air depends on the initial length of the beads typed on the line The trapezium drew, now take pins and begin to form our air. I start from the right upper corner and descending the quiet down. The end of the closed chain is fixed in the lower left corner. It is important! Two free end of the fishing line (remember about 50-70 cm?) We just turned out to be left and right. We will need to mount the lock.
After we have in a similar way distributed the whole chain, we take a hook that it knitted, and we ride on it on one side all the loops under the pins. That's the way:
We remove the pins, all hinges on the hook.
Now we take a needle and flash all these loops with a fishing line.
This is what should happen:
We also do the same on the other hand. And that's what happens. Almost ready, it remains only to attach the lock.
I stand on the fishing line, a few beads, a ring for fastening the lock, all this is flashing several times a fishing line and here's the result:
Voila! Necklace is ready!
Thanks to the author Elena Lagutkina !!