Materials:
- Sewer pipe with a diameter of 150 or 200 mm;
- Polypropylene (PP) or polyvinyl chloride (PVC) pipe with a diameter of 25 mm;
- Furniture loops - 2 pcs;
- Bolts with nuts M6 - 5 pcs;
- Rivets plus a rivet gun;
- Caid latch for drawers;
- Super glue;
- Aerosol paint.
Establish to manufacture.
Cut from the pipe that will act as a body, 4 rings with a width of 5-10 mm. We apply markup and cut the rings.
From the same pipe, we cut a blank length of about 30 cm. The length of the workpiece is chosen on the basis of what is planned to be stored in the case.
To make the sidewalls of the future drawer, take a cut of the pipe and cut it along. The cut segment is placed in the oven, heated to 200 degrees Celsius.
After waiting for 3-5 minutes, removing plastic. It will be soft and it will look like a sheet of paper. We put it on an even foundation, giving all the piece of tiles. Cut two rounds with a diameter of equal to the inner diameter of the pipe.
We put on the pipe markup under the legs. Drills holes, insert and clamp M6 bolts closer to the edges of the pipe.
I appline the markup of the future cover on the pipe, after which I cut it out. I cut down the slots under the loop. We drill holes under the loop on the box and the lid.
We cut the narrow rings and install them inside the box, after which it is cut unnecessary by fixing everything superclaim, thus forming the sidewalls.
We take a pipe of a pipe with a diameter of 25 mm and a length of 25 cm. Place the blanks on 5 parts (25 mm, 45 mm, 110 mm, 45 mm, 25 mm).
Heat the tube with a hairdryer or gas and bend the handle by tags. Drills a hole for the mounting handle to the box cover.
Pray plastic parts, after removing the legs of the bolts. After drying, screw them back. Fix the hinges to the housing and the lid using rivets. In the same way, fasten the handle to the lid.
We apply markup for fastening the cape latch and drill holes. The latch is installed on rivets. In this case, if the latch does not have a retainer, you can use the screw with the nut.
