Today we will tell how to make five useful homemade tools for their own hands.
Hello everyone! In this issue, I will show you some interesting ideas some of whom may like you.
If you need to smoothly cut the plastic or metal pipe, then the next tool will help you.
Take the metric ribbon from the roulette, cut off 40-50 cm, smoothly folding the ends together, drill two holes and roll with small cogs.
Now you can easily draw the line on which you make perfectly smooth cut.
If the car's repair in a hard-to-reach place is tormented by a horn key, you lose a lot of time or patience, and the ratchet can not get it, perhaps you need a screwdriver with a cardan.
To do this, we need an adapter for heads from screwdriver with replaceable nozzles.
We sharpen the nozzle and a screwdriver with a nazium or a grinder, cut from a suitable bolt to approximately 2.5 centimeters. On both ends, drilled two holes, we make two cuts 90 degrees relative to each other. We just left to drill holes in a screwdriver with an adapter and to shave.
Now unscrewing the bolt or nut in a difficult place, you will not lose liters of sweat for every millimeter with a horn key))
Do you need to fill the liquid into a container with a small neck? In this case, a small funnel can be made from the fuel filter. It is only cut off the output part of the filter and a funnel is ready.
You could notice the inconvenience when changing drills in the cartridge drill, namely the slip of the keys's teeth. You can upgrade it with a screwdriver with a thick rod.
Having made a slot in the rod screwdriver and walking the key rod insert it into the slot, and the hole is tightened by the screw.
Now you can not worry about the fact that the teeth of the cartridge break down when they will change the drills in the team and, moreover, thanks to the bright handle, the key search among the heap of tools will be easier.
If you need to draw a circumference of a large diameter, and you do not have a large circulation, then you need to make holes on the joinery of the carbon through each centimeter.
Now installing the drill or carnation on the zero mark, you can draw the circle of the diameter we need.
And also after such a refinement, it became easier to draw longitudinal lines.
Perhaps the reader was something not clear, in which case you can watch the video.