Flowers from polymer clay MK

Anonim

Flowers from polymer clay MK

Tools: Steel wire, bamboo stick, pliers, nippers, pastel, brush, plow glue.

Flowers from polymer clay MK

1. Measure the wire of the desired length and bite. One edge bend pliers and make an eye.

2. We take not a lot of clay and make the basis in the form of a drop (the more rose, the greater the base).

Flowers from polymer clay MK

3, Make 1 petal: not a lot of clay, well smear, we make a ball and flatter, the form should be oval and above the base. Screw to the base. The second and third petal is the same. 1,2,3 (one size).

Flowers from polymer clay MK

4. 4,5,6,7 Larger petals. We attach the form: We make an oval with your hands and with the help of a bamboo sticks at the top of the petal make a relief, slightly pressing tightening and spinning, in the middle of the petal we make a deepening (put the petal on the Lanton and press the middle of the petal to the middle), forming the flower.

Flowers from polymer clay MK

5. 8,9,10,11 petals of even larger size. Stlikely as №4.

Flowers from polymer clay MK

6. 12, 13, 14, 15, 16, 17 petals of even larger size. Still as well as №4.

7. Code will dry toning: we take pastel and knife scrape, make a powder. The middle of the flower toning light green. Edges Tinging brown.

Flowers from polymer clay MK

Flowers from polymer clay MK

8. CHASELISTICS: Take green clay, roll into the ball, make a droplet from the ball and pull it out. With the help of the bamboo sticks roll along, we deepen the middle, and raise the edges and slightly tune. Draw the desired shape and glue PVA glue.

Flowers from polymer clay MK

9. Stem: We make a thin sausage (twice the wire thickness), marked with wire over the entire length.

Flowers from polymer clay MK

10. Leaves.

Tools: Wire, Scissors, Shilo, Molda homemade, butter or cream.

Flowers from polymer clay MK

11. Cut off the wire of the desired length, cut out the sausage from clay and press it into it with wire. We do not wait until dried up.

Flowers from polymer clay MK

12. As before, I knew an oval from the ball, you can roll the rolling pin on the smooth surface. On, lubricated with cream Mold, we impose the resulting oval and harvested wire and we climb weak presses.

Flowers from polymer clay MK

13. Slowly sprinkle leaves from Molda. Put on a smooth surface and cut out a homemade form.

14. Remove the desired bends leaf and let dry.

Flowers from polymer clay MK

15. Cut the scissors all too much.

16. Tinging: Pastel's aunts-green, yellow and burgundy color.

Flowers from polymer clay MK

And here is the result! I wish good luck to all who decided to use my MK.

Flowers from polymer clay MK

Flowers from polymer clay MK

Flowers from polymer clay MK

Flowers from polymer clay MK

Read more