I want to introduce you a small collection of mini-cakes and a few words about how to do them.
We will need a foam of 2 cm high or 5 cm. Of 2 cm of foam, we cut out 3 blanks, both edges of 12 cm (or optional), spin in the form of a piece of cake and glue them with m / act. I glued thermopystole. And if the foam is 5 cm, then one bottle and glue do not need.
We apply pointing the glue, first for one, then on another surface of the workpiece and glit to the leaf of corrugated, leaving a bend allowance.
You can cut off the ribbon shir. 2 cm, and the length of the edge of the workpiece. Printed on the edge of the workpiece so that it performs above the edge of 1 cm and stretch a bit, turn out like a fringe. On some submitted cakes there is such.
On the side parts we glue two-sided adhesion, it is preferably not wide (not like that as well!) If we are wide, then in the middle, and if not wide, then at the top and bottom (for bend).
The next step is candy! Tails fold (without spin!) And fix the pieces of transparent tape to the center of the candy, the ripping seam. We glue the holding with candy smoothly, on the bilateral tape for the side sides of the workpiece, following the name to be directed in one direction and the missed seam was glued to the scotch.
And further, it's about the design and flowers ... And the colors and master classes at http://supercook.ru/Decorage/Decoration-05.html is apparently not apparently !!!
Well, now, my collection!
