Now I am working to create a forest bouquet, I want to have berries and mushrooms in it, just for me you need an amanita, I decided to share my master class, I hope someone will come in handy!
All you need for work is in the photo.
I did not want to spend a lot of clay, so I made the basis for a foil mushroom, paint clay into the right colors.
Let's start with the cap, we take a red clay, make a "cake" from it not thin and fault with top foil with PVA glue, we glue evenly distributing, with the help of a driver smoothed and align the clay. Let me dry a little. As soon as the clay dried and does not stick to his hands, the handprints remain, you can glue white clay in the same way as red, but no longer worth smooth by water.
To make the plates from below the mushroom, we need a tweezer curved, we divide the white part to 4 equal triangles with it and only after that in each part we make a plate.
When all the plates are made, smooth and align the clay between the plates using a stack or needle. You can also the tip of the tweezers to add more small plates, along the edge of the mushroom.
After all the plates are outlined, they need to be sophisticated with the help of the same tweezers, try to sink the ringer with the edge of the mushroom.
All the hat is ready, let it dry. We proceed to the feet of the mushroom, roll off the clay white sausage, flatten and rocked the fooled foil with the feet. Align all the joints with the help of a driver, let it dry a little, so that the clay does not stick to the tool. Brek stack with a ball small and at the base of the fungus make such unevenness, then we carry out a brush throughout the trunk make roughness.
We make a skirt then, clay roll in a circle, thin, with the help of a wooden stick I will drown the edge (wooden leaves after myself a beautiful pattern on the clay) so that the waves were obtained as in the photo. Then cut the middle and cut the circle on half. We will thin the edge that will be glued to the leg of the fungus, but already without waves and glue, with the help of water we also clean the irregularity and make the butt smooth. Make skirts as much as you want :) You can look like a skirt with scissors to form.
When the leg dried, you can glue the hat to it, I glued to the PVA. Now everything should dry very well, so that the hat does not disappear from the leg. I toned the leg and a hat with pastels, can be oil paints but long to wait when it dries. Hat red and yellow, brown leg, beige, black and little green.
Then, to draw the specks whites on a hat, you need to dissolve white clay with water to the consistency by estimates (you can simply draw paints) and apply the toothpick on the hat.
Roll over white clay into a thin layer and pour into small pieces.
Glit them on PVA to drawn stains, just not on everything, but partly. In general, there are various specks, it is already you choose yourself as you like more :)
Now let everyone get dry and you can cover with a matte varnish, I coated a little glossy.
And that's all, the torching turned out! Thanks for attention! :)
If you have questions, write in the comments, I will answer :)
