On the Internet, Ineta is easy to find a lot of tips, how to make a particular flower for a bouquet of sweets. But it is harder to find like a bouquet to collect. As it does not particularly focus on this attention, although each master has its own secrets.
Today I will share how to fix the foundation for a bouquet in a glass or plastic glass, a glass, a fuasher, etc., in short, vessel. And not just consolidate, but consolidate so that you can subsequently use this vessel. Consequently, the conclusion: no glue!
I will show your way on the example of a male beer bouquet (especially relevant in the aprimion of the male holiday). The basis will be attached to the beer mug, which we plan to use in the future for the purpose.
1. It is necessary to cut the base on the inner diameter of the circle. For such bouquets, I use a floral oasis - it is easier to cut it on the desired size, work will be careful.
To schedule borders for trimming, I turn the glass and slightly pressed on the oasis.
As a result, we get such a contour
2. Along the contour, cut the cylinder. Cut from the inner diameter, you can even half a million meter (and if we use a thick grid to finish, then 1 mm less internal diameter). When I cut the cylinder, then periodically only follow it to the glass: it must be achieved so that it should be done without much pressure He entered the mug, but at the same time did not hang out in it. The ideal form should not be particularly necessary - the cylinder will be hidden by the decor. This is where you can already stop.
3. At the previous stage there were several approaches to fitting the base. The basis will slowly crumble, and prints remain from our fingers. Therefore, an important point: we take a cloth and rub the glass to the brilliance. You can pre-wash or use the glass tools.
4. Before you begin to insert the basis into your vessel, we define what we will decorate. If the choice fell on the grid or organz, then our foundation additionally put in a small bag so that the crumbs do not blur the glass. If we decorate the film, then we skip this stage.
5. From the film, grid, organza cut the square in such a size to fully hide our cylinder for the base and remains a stock for further decor. I measure the film, a length equal to the height of the cylinder + thickness (diameter) + cylinder height + at 10-15 cm on each side. Then make a sliced strip
6. We place the cylinder into the center of the square, collect corners and slightly insert into a glass
7. We start straightening the film with beautiful folds and slowly insert the foundation is deeper and deeper into a glass.
8. Insert the foundation for the necessary depth.
Since the folds gradually become more and more, the foundation has to insert with tension, at the expense of which it is attached to the vessel. I do not cut an extra film on the rim on the rim, it will perform the role of extreme pantics (doinched a little later in the height of the panties inserted). In addition, for the left edges will be able to remove our foundation from the circle for its further use.
Source http://skrapttt.blogspot.ru/2013/02/kreplenie-osnovu-doma-buketa-master-klass.html
An example of bouquets
