Women are low growth difficult to choose their clothes - the sleeves are always long, the waist is not on the spot, the pants are dirty on the floor ... the way out is simple: they can go, because any pattern can be shortened!
The main rule of selection pattern: For a coat, jackets, dresses and blouses, the main measure is grabbing breasts, and for skirts and trousers - grumps of hips.
If your main standards coincide with the Burda table, but the growth is not standard, and the low (up to 160 cm), You can shorten the pattern on the auxiliary lines marked in the drawings to the specified number of millimeters.
If you are below 160 cm or your main measurements differ from those in the Burda table, The number of millimeters to which the pattern should be shortened should be determined by yourself.
Important: For coats, jackets, dresses and blouses, the pattern is shortened at two levels: at the half height of the armhole - on 1/3 of the desired number of millimeters and between the waist and the waist line - by 2/3 of the desired number of millimeters.
In addition, on approx. 15x below the waistline need to shorten the pattern by another 1 cm. So that after adjusting the transition / backrest, the sleeve entered the armor, it should be shortened accordingly on the Okat site, and the sleeve with a flat head is narrowed along the seam lines to the lower edge.
Pants at the top level are shortened by 10 mm, and on each of the two other levels - above and below the knee - on half the remaining length, to which they need to be shortened.
The figures show how to draw auxiliary (intermittent) lines.
Basic rule: Lines are drawn strictly at right angles to the direction of the direction of the share thread!
Extra-Council: Before proceeding with the adjustment of the pattern, attach it to yourself and go to the large mirror - you will immediately become clear, where and how much you need to shorten the pattern!
Important: The models with a vertical folding on the chest before shorting the pattern laid this outlet on it (Fig. B), having previously cutting the pattern from the side cut to the vertex of the outlet (Fig. A).
After shorting, glue the edges of the resulting horizontal folding and decompose the depth of the vertical fold.
Correction pattern
Above or below the adjustment line, draw a parallel line at such a distance to which you want to shorten the pattern. Stay on the pattern a fold by combining both drawn lines.THE CHOICE IS YOURS! - comparable sizes table
Standard dimensions 42 44 46 48 50 52 54
Sizes for low 21 22 23 24 25 26 27
Just divide in half! The measurements of both groups completely coincide, the difference only in growth: the standard size implies an increase of 168 cm, and the size for low - 160 cm.